How to Apply Heat Transfer Vinyl (HTV) on Glass Tutorial
Step 1: Requires a non stick pressing sheet on top of the design
Step 2: Press gently on the design for a couples seconds on each area of the design till the whole design has been covered, take note you do not need to press as long as you would on fabric
Step 3: Wait a couple minutes for the glass to cool before you peel the carrier sheet. Taking note the glass will be very very hot!!Heat Press Machine
Step 1: Lay down a towel on the bottom of the pad of the heat press, this helps to protect the glass.
Step 2: Do not use excessive pressure as the glass can break from too much pressure, so gently press down for several seconds.
Step 3: f you have a clam shell style press that is designed where the top heating plate comes down at an angle you will want to rotate your design so it hits all the angles at the right angle.
Step 4: Wait a couple minutes for the glass to cool before peeling and be very careful when peeling because the glass may be very hot.**note in between steps do not put your project back on your cutting matt due to the heat produced by the glass will warp your cutting matt.