How to Apply Siser Metal EasyWeed Heat Transfer Vinyl
How to Apply Sisers Metal HTV (Gold or Silver HTV) When choosing supplies for your DIY projects, it’s important to have a plan in place. This allows you to ensure that you gather all of the items you require including the knowledge on how to apply them.
Get that Metallic Foil Look with a Super Soft Feel!
**Do you know about the Heat Press Weeding Trick?? if not you can view here, weeding doesn’t have to be a chore, see the utube video here the time saving by using a heat press-this will make your life a lot easier (Heating the platen and weeding the design on a heated surface. Feel free to share this with your friends and on facebook!! What are the cutter settings for my Cricut with Siser Metal HTV?- Blade: Standard
- Setting: Iron on
- Blade: Standard, 2
- Material: Heat Transfer, Smooth
- Speed:8
- Force: 6
- Blade: Standard, 2
- Cut Speed:1
- Cut Pressure:3
- Blade: 4°
- Gram Force: 80-90
- Offset: .250
- Speed: 30-50cm/s
- Blade: 45°
- Gram Force: 8-9
- Tool” CB09U+0
- Speed: 30cm/s
- Cut in reverse
- Weed excess material
- Preheat garment for 2-3 seconds
- Apply design at 305°F/150°C
- Use medium pressure for 10-15 seconds
- Peel carrier COLD
- Set iron dial between Cotton and Linen
- Cover design with Krafter paper or a non stick cover sheet
- Place on a flat, hard surface (not an ironing board)
- Press iron with medium/firm pressure (do not slide iron)
- Press each section of the design for 10-15 seconds
- If areas of design lift after application replace cover sheet and re press for 5-10 seconds
- Peel carrier COLD